1,651 Vertical waviness/Extruder stepper precision

by Shameless

1,652 Help! X axes stange noise

by sigiel

1,653 Prints Warping and Peeling up

by Mr.Factotum

1,654 SD3 Extruder fan runs when only connected to USB

by johnforeman

1,655 Extruder strips filament occasionally on long prints.

by pastprimitive

1,656 Beginner Troubles

by bpulst

1,657 Help! Gaps on Horizontal Surfaces

by Lurkios

1,658 Atock extruder, heater keeps shutting down.

by Heartlander

1,659 Problem with printing anything but straight lines

by gettingbored

1,660 \sloppy infill

by MolecularConcept

1,661 bow in aluminum plate or rods

by techbuilder2175

1,662 SD3 Bed heater failure

by Kerry

1,663 X Axis Slant after 10mm or so

by tomirving92

1,664 Help! SD2 extruder doesn't get hot

by longnagai

1,665 Feedrate too high? Forgot the original settings for slic3r

by 3dcad

1,666 Print Curling - Not print surface issue

by Krythis

1,667 Layers not sticking to layers

by techbuilder2175

1,668 Extruder jam and Urgent print help!

by Stevos758

1,669 Printer always prints unreasonably super fast halfway

by mjamesf

1,670 loading firmware

by lowell.e

1,671 Where to get replacement Nozzles and Barrels?

by hcsceo

1,672 Measurement system for belt tension?

by jroos1228

1,673 Raising the Maximum extruder temp.

by sdf013

1,674 Solidoodle 2 First Layer uneven

by vong888

1,675 Newbie 1st day - Can't even remove test filament.

by cocacough

1,676 Help! A puff of smoke, bad smell, and now I can't connect to the printer

by 3d-oodler

1,677 Printing Moving Parts help..

by johnforeman

1,678 Remove all doubt from belt tensioning.

by pastprimitive

1,679 extruder calibration

by michael.rosplock

1,680 Help! Printer is doing some funky stuff

by solid801