1,801 Error:Line Number is not Last Line Number+1, Last Line: 4

by rjp350z

1,802 Heater problems

by pretenda

1,803 Just got my solidoodle 2

by teddygrahams

1,804 Very hot X stepper motor

by fischelbyxa

1,805 Tighten X belt

by pretenda

1,806 Closed: Orange Ozz. Thermistor?

by Rocketman

1,807 Extruder and bed over temp error/problem

by darrell.adams

1,808 can't extract filament

by zragg

1,809 Extrusion temperature guidelines / calibration ?

by spapadim

1,810 Can't load filament

by g33k_girl

1,811 USB Port is loose.

by tick72

1,812 Extreme shift after a few layers

by kaldonis

1,813 Help! I REALLY need to know where I can find more thermistor harnesses.

by mlove01001101

1,814 Fan was incorrectly wired on arrival.

by neoblood3d

1,815 Newbie can't keep the extruder from ramming left and front sides

by PrinterPapa

1,816 No sticky

by Skyman25

1,817 z-axis leadscrew specs/comparable parts for S3

by rsheldiii

1,818 disable "gap filling"?

by dkeeling728

1,819 I got this problem on my last print

by fedebirromane

1,820Moved: Tool/setting for remove support

by RavensCrest

  • No reply information
  • No viewing information
  • No last post information

1,821 Base Model - Acrylic Build Platform

by musisold-fun

1,822 I melted My Hot End

by Mic

1,823 Hot end isn't hot - How to repair

by danny

1,824 Extrusion clog from hell

by schlegz

1,825 ABS to PLA and Back again.

by kkciampa

1,826 Out-of-the-box retract/extrude problems

by pascal

1,827 Plastic sticks to outside of Extruder

by jellyphant

1,828 Help! Zip tie around extruder for Soli 3

by acediac

1,829 No drivers for "USB serial" device XP 32bit

by metaldrgn

1,830 When does the fan of the extruder stepper motor run?

by protorix