E3D Titan extruder (Page 15 of 16)

I've got mine down to where I can just unscrew the two bottom screws on the Titan, and just barely untighten the top two screws.  The Stepper Motor and Titan come out as one piece, leaving the carriage in its place.

SO MUCH easier than taking the carriage off. 

When I need to put it back in, the motor mount and titan just sandwich over the carriage.

5 minutes to get it off, 8 to get it back on.

I get zero warping with PLA, some with ABS if I don't use brim. 

I have a few prints that have filled almost the entire print bed, and no warping.   Here is a 31 hour print with glow in the dark PLA:

https://www.youtube.com/watch?v=3VgG62rNItg

PLA is awesome for large prints!

Yeah, pla is the way to go for large prints.
To be honest, I use pla 99% of the time now.
If I use abs, I print at 240°C with the bed at 90°C and close the door and lid.

I think I can help with that: http://www.soliforum.com/topic/15009/e3 … iage-beta/

I did a 6 hour print with Inland Flexible Natural overnight.   I think its TPU.

Ran it nice and slow...  12mm/s max

Worked like a charm!

The combo of repetier firmware and e3d upgrades has turned the cheapest 3D printer on the market into a beast!

I wasn't willing to try any faster for my first print with flexies.  I'd be willing to push it for testing, but from what we've heard i doubt we'll get much over 15mm/sec.

I'm not quite sure what the problem is with faster speeds.  The design seems ideal.

After making an improvement to my spool holder so the filament nows flows more smoothly, I just finished a print with TPU at 25mm/s.
I tried 30mm/s and it failed but 25mm/s is way better than I've managed with other flexi filaments.

What extruder assembly ??

Does anyone know how to configure the XYZ Printer to work with the new 400 stepper motor that is supplied with the TITAN Extruder?

Read through all post and i would like to know where to start with a virgin davinci with repetier to dot he titan/v6 mod as it stand currently. Is wiley's design working well yet? I printed it with a couple flaws and ended up cutting off the belt holder while not thinking of what it was for as this is where my slight printing error occurred.  I am using black ABS. I have a clone e#d v6 in front of me and a clone titan on the way(hopefully this will work out and fit as it is all I could afford.) I'm using CuraEngine as it seems to give better results for me right now and my settings for cura are attached.

The Titan Clone I Ordered: http://www.ebay.com/itm/182314917213
The Clone V6 I ordered: http://www.ebay.com/itm/172138307610?_t … EBIDX%3AIT

Note that the v6 did NOT come with ANY PTFE tubing. Not even in the heatbreak.

I didn't even look into the Lite 6, seems to be the way to go for now. I am such a n00b. I just figured out how to rotate the object to the correct side to print. lesson learner, Filament wasted. Print time reduced, no structure needed.

Thats a familiar name :-) I have not printed anything on my Da Vinci in 6 months but I was having issues with my other printer so I thought I would fire it up again.

how did you make adjustments on the Z end stop did you just move it?