Topic: Wont Stop Heating
My extruder won't stop heating up. I have it set at 195, and it gets over 220. It has already melted the peek pipe. I have a spare hot end but I don't want to put it in until it stops heating past the setting.
Any ideas?
1 2013-05-27 05:52:28 (edited by SpikedGoat 2013-05-28 04:51:18)
2 2013-05-27 06:03:03 (edited by 2n2r5 2013-05-27 14:11:27)
- 2n2r5
- Member
- Offline
Re: Wont Stop Heating
For me it was a bad mosfet. I switch the ones for the bed and the hotend on the board since they are the same mosfet.
http://www.soliforum.com/topic/2399/hot … down-320c/
SD3 w/ mods:
Glass bed with QU-BD heat pad upgrade, threadless ballscrew w/ 8mm smooth rod, spectra line belt replacement, lawsy MK5 extruder, Lawsy replacement carriage, E3D hotend, Ramps 1.4 w/ reprap discount controller, DRV8825 drivers, 12v 30A PS, Acrylic case, Overkill Y-idlers, Filament alarm, Extruder fan + more.
Glass bed with QU-BD heat pad upgrade, threadless ballscrew w/ 8mm smooth rod, spectra line belt replacement, lawsy MK5 extruder, Lawsy replacement carriage, E3D hotend, Ramps 1.4 w/ reprap discount controller, DRV8825 drivers, 12v 30A PS, Acrylic case, Overkill Y-idlers, Filament alarm, Extruder fan + more.
Re: Wont Stop Heating
which part is the Mosfet? Where would i get one of those?
- 2n2r5
- Member
- Offline
Re: Wont Stop Heating
https://www.sparkfun.com/products/10213
SD3 w/ mods:
Glass bed with QU-BD heat pad upgrade, threadless ballscrew w/ 8mm smooth rod, spectra line belt replacement, lawsy MK5 extruder, Lawsy replacement carriage, E3D hotend, Ramps 1.4 w/ reprap discount controller, DRV8825 drivers, 12v 30A PS, Acrylic case, Overkill Y-idlers, Filament alarm, Extruder fan + more.
Glass bed with QU-BD heat pad upgrade, threadless ballscrew w/ 8mm smooth rod, spectra line belt replacement, lawsy MK5 extruder, Lawsy replacement carriage, E3D hotend, Ramps 1.4 w/ reprap discount controller, DRV8825 drivers, 12v 30A PS, Acrylic case, Overkill Y-idlers, Filament alarm, Extruder fan + more.
Re: Wont Stop Heating
I fixed my melted peek with a 6mm helicoil from an auto parts store.
Re: Wont Stop Heating
Thanks it's working now.