<![CDATA[SoliForum - 3D Printing Community — Wont Stop Heating]]> https://www.soliforum.com/topic/2569/wont-stop-heating/ Mon, 27 May 2013 23:10:49 +0000 PunBB <![CDATA[Re: Wont Stop Heating]]> https://www.soliforum.com/post/24260/#p24260 Thanks it's working now.

]]> Mon, 27 May 2013 23:10:49 +0000 https://www.soliforum.com/post/24260/#p24260 <![CDATA[Re: Wont Stop Heating]]> https://www.soliforum.com/post/24217/#p24217 I fixed my melted peek with a 6mm helicoil from an auto parts store.

]]> Mon, 27 May 2013 12:24:49 +0000 https://www.soliforum.com/post/24217/#p24217 <![CDATA[Re: Wont Stop Heating]]> https://www.soliforum.com/post/24210/#p24210 https://www.sparkfun.com/products/10213

]]> Mon, 27 May 2013 06:46:19 +0000 https://www.soliforum.com/post/24210/#p24210 <![CDATA[Re: Wont Stop Heating]]> https://www.soliforum.com/post/24209/#p24209 which part is the Mosfet?  Where would i get one of those?

]]> Mon, 27 May 2013 06:44:22 +0000 https://www.soliforum.com/post/24209/#p24209 <![CDATA[Re: Wont Stop Heating]]> https://www.soliforum.com/post/24208/#p24208 For me it was a bad mosfet. I switch the ones for the bed and the hotend on the board since they are the same mosfet.

http://www.soliforum.com/topic/2399/hot … down-320c/

]]> Mon, 27 May 2013 06:03:03 +0000 https://www.soliforum.com/post/24208/#p24208 <![CDATA[Wont Stop Heating]]> https://www.soliforum.com/post/24207/#p24207 My extruder won't stop heating up.  I have it set at 195, and it gets over 220.  It has already melted the peek pipe.  I have a spare hot end but I don't want to put it in until it stops heating past the setting.

Any ideas?

]]> Mon, 27 May 2013 05:52:28 +0000 https://www.soliforum.com/post/24207/#p24207