1 Topic by FakeTomb898

  • FakeTomb898
  • Newbie
  • Offline
  • Registered: 2017-10-18
  • Posts: 1

Topic: da Vincin Jr 1.0: No Filament Error

So as I was trying to start a print on the XYZware it said I had 0% filament left even though their is visibly about half the role and trying to print after that would give me the error code: 0029 which was not posted on the XYZprinting website giving me no clue on how to fix this (and yes the chip for the role is on the role).

2 Reply by mjf55 (edited by mjf55 2017-10-18 05:29:16)

  • mjf55
  • Member
  • Offline
  • From: Raleigh, NC
  • Registered: 2017-06-01
  • Posts: 336

Re: da Vincin Jr 1.0: No Filament Error

As noted in thingiverse, you have a davinci jr 1.0.  Need to known the firmware level.

Error 0029 just says there is no filament in the spool. 
http://wiki.xyzprinting.com/labs_2_en_u … eshooting/

3 Reply by yizhou.he (edited by yizhou.he 2017-10-18 17:05:36)

  • yizhou.he
  • yizhou.he
  • Member
  • Offline
  • From: Boston, MA
  • Registered: 2017-07-05
  • Posts: 1,322

Re: da Vincin Jr 1.0: No Filament Error

unfortunately, you have a davinci jr 1.0. XYZware it said I had 0% filament left even though their is visibly about half the role is totally normal. Buy an new roll of filament will fix the problem.

XYZware calculate much much filament you want the printer to print, not the actual filament you used. Normally, if all your print are successful, you get about 20% or less filament left. If you have cancel or unfinished print, you get more left.

If you are ok with it, just keep buying more filament at slightly higher price (about 4X unit price), you will get the model you want to print, and if you only print occasionally, it save you a lots of trouble. you can still use the filament if you got one of the 3D printer pen to glue of fix your prints.

If you don't like it, and your printer still under warranty, return it.

If you don't like it, and your printer not under warranty, sell it on ebay for half of the price, trust me, you saved a lot of money by doing so if you use the printer a lot.

If you are confident on your technical skill and determined to learn how 3D printer works (not recommended if you are not):

http://www.soliforum.com/topic/15815/xy … w-hacking/

http://www.soliforum.com/topic/15273/ho … -ramps-14/

http://www.soliforum.com/topic/16694/ho … updated-2/

http://www.soliforum.com/topic/16797/xy … ification/

(Da Vinci 1.0, Jr. 1.0 RAMPS, miniMaker) X4, (Creality CR-10S, CR-10 mini, Ender-3) X4, Anycubic MEGA X4, Anycubic Chrion X1, ADMILAB Gantry X2 (MonoPrice Maker Select V2, Plus, Ultimate)X4--Select mini X1, Anycubic photon X4, Wanhao duplicate D7 X1.
iNSTONE Inventor Pro X2, CTC Dual X2, ANET-A8, Hictop 3DP-11, Solidoodle Press, FLSUN I3 2017X1