@Stevos758: I'd be interested in one of these as well if you or wardjr made up a batch...
@wardjr: I looked at moving the probe to the left side BUT because it offsets off the built platform when homed, when it goes to do the z-home, it won't work. Since it offsets by 205mm for the print head to be off the build platform, if I was to offset the probe, it would end up being on the right side anyways The firmware seems to force it to the x/y home position before it allows z-homing.
On a side note, I'm SOOO close on this autoleveling. Last night got it taking readings from the 4 points, but for some reason it's not raising the bed when ready to print for the offset, so guess I will be digging thru the configuration.h file for a bit
SD3, Lawsy Carriages with GT2 belts on x axis, BLTouch, Bondtech BMG extruder, E3D v6 via bowden, MIC6 bed with 200W heater w/SSR relay and a RUMBA controller