Topic: Wiring Bundle Guide
This is a take on jon_bondy's belt shield posted here... http://www.soliforum.com/topic/331/wiri … n-by-case/
I liked his initial design but it didn't allow for me to continue to use my case and it didn't guide the wire bundle up into the gap he had designed into the part. I redesigned it to be much thinner and to be able to just friction hold the top lip of the printer frame. It allows you to continue to use your case while only raising it up 0.1". I have included the file for some spacers if you want to raise the opposite side by a tenth of an inch as well.
So far it seems to be holding up pretty well.
Note: make sure you rotate the part so it prints vertically.
Filastruder
NYLON (taulman): http://www.soliforum.com/topic/466/nylon/