Re: SD Press - Under the Kimono
Heh. So I was hour 3 in a 4.5hr print and I hear the printer stop in it's tracks. Basically acted like the print was finished. Confused and pissed I pulled the print off and attempted the home the machine. It only homed in one direction. So I am looking around in the machine and everything looks 'okay'. I try to home the machine again, same thing. Only homed in one direction. So I shut everything down and slowly started taking everything apart and I found this...
The header was still attached, but the solder points where not touching the pads. It was just floating there.
Argh. What the hell SD? What the hell.
SD2 / E3D v6 / Direct Drive / Mk8 Gear / RAMBo v1.3 / PEI Bed / Anti Z backlash mod / Ikea Expedite enclosure.
Both Driven by Octoprint (devel) via a RPi B+ / Neopixel status alerts / GPIO Controlled SSR / (SD2) 450 Watt PSU for remote power-up/shutdown.