Re: how to set up second printer?
ok thank you
You are not logged in. Please login or register.
SoliForum - 3D Printing Community → Software & Firmware → how to set up second printer?
ok thank you
Oh, and check / switch out the USB cable...
what do mean?
Usb cord is good
Since you mentioned you have already flashed different selections of firmware and seem comfortable doing it, then the only other thing I can advise is to go to the Repetier Firmware site and start trying to modify particular settings in your configuration.h and other related files.
http://www.repetier.com/documentation/r … tallation/
I wish I could help further...
Well I got it back to where I can turn the fan on and off and heat the extruder. but that is all so far
Well I got it back to where I can turn the fan on and off and heat the extruder. but that is all so far
This is Marlin, configured for a 1.0 on RAMPS 1.4. Flash it and see where it gets you..
Hi I am not trying to get if on my davinci. Trying to get my new smartone 200 up and running. Thanks
Hi I am not trying to get if on my davinci. Trying to get my new smartone 200 up and running. Thanks
It should still work, as my Da Vinci is no longer a Da Vinci but a RAMPS 1.4.
HI I do not have a .rar file opener. can you send it in a different file format?
I dont recommend using low com port numbers as new 'plug and play' items will steal the lowest unused port (since 3D printers run as virtual serial they are not seen) use highest numbers like 12-24 to avoid issues in future when adding new hardware like I did. and techs couldnt fix it. took me a week to figure it out
search net for 7zip. it opens lots of odd types
Intallled 7zip and your file will not install?
In marlin that I have already installed it shows no bed and shows extruder temp at 464 degrees? with the extruder turned off or on
Ok got the temp on the exturder problem corrected in the firmware. Now bed still now showing up in repiter host?
Got the bed to show up now, only thing left is to get the stepper motors to move. Can not figure it out yet. I can bump them 1mm and then they stop
Got the bed to show up now, only thing left is to get the stepper motors to move. Can not figure it out yet. I can bump them 1mm and then they stop
The problem is with your endstops. I would just work on one axis at a time.
Ok thanks.
Printer not working .What is the problem?
Printer not working .What is the problem?
That's a very specific problem, hold on while I get you the answer
I can not use my printer . its stop work after sometimes and sometimes.whats the problem can be behind this problem?
If you guys want help you need to be specific. I know it may be hard due to language and such but we need as much detail as possible. Like when does stop, what are the temperatures when stops? Are there any errors displayed by the printer or the host? What are you printing? Is your machine stock and not modified? What host are you using. That is just some of the information we need.
I can not use my printer . its stop work after sometimes and sometimes.whats the problem can be behind this problem?
Something doesn't add up here. http://www.soliforum.com/post/100572/#p100572
SoliForum - 3D Printing Community → Software & Firmware → how to set up second printer?
Powered by PunBB, supported by Informer Technologies, Inc.