1 Topic by BFresh

  • BFresh
  • BFresh
  • Member
  • Offline
  • Registered: 2013-03-11
  • Posts: 118

Topic: Show off your printing station

With the 3D printer, computer to run RH, plus all the reels of filament and tools/spares involved in running a 3D printer, the whole setup can consume quite a bit of space.

Post a photo here of your innovative/organised setup.

I have 2 SD3s, and a PC (plus monitor/KB/mouse) and a laptop to run them. I am looking to build a bespoke printing station (on wheels), so I am looking for clever, space saving ideas.

Is it a bad idea to have electronics or rolls of filament above the printers due to heat? Both printers have covers.

Industrial Designer
Fresh Design Works (UK)
www.freshdesignworks.co.uk

BFresh's Website

2 Reply by Serin

  • Serin
  • Serin
  • Member
  • Offline
  • Registered: 2013-08-13
  • Posts: 382

Re: Show off your printing station

Innovative? Organised? Haaahhhhhhh!
Wobbly glass desk plus wires everywhere.
Just picture spaghetti and you'll have a good idea of my setup tongue

This is a crowd funding thing that I'm running: http://www.gofundme.com/bvi140 It's for pretty selfish reasons tongue

3 Reply by michael.t.albers

  • michael.t.albers
  • Member
  • Offline
  • Registered: 2013-06-07
  • Posts: 164

Re: Show off your printing station

I would take a look at Toolbox's case and build off off that one.  The case is enclosed with a two spool holder.  Put two of those together and then a shelf of some type for your computer and you might have a lil' somethin, somethin!