<![CDATA[SoliForum - 3D Printing Community — Show off your printing station]]> https://www.soliforum.com/topic/7034/show-off-your-printing-station/ Mon, 21 Jul 2014 12:15:20 +0000 PunBB <![CDATA[Re: Show off your printing station]]> https://www.soliforum.com/post/60873/#p60873 I would take a look at Toolbox's case and build off off that one.  The case is enclosed with a two spool holder.  Put two of those together and then a shelf of some type for your computer and you might have a lil' somethin, somethin!

]]> Mon, 21 Jul 2014 12:15:20 +0000 https://www.soliforum.com/post/60873/#p60873 <![CDATA[Re: Show off your printing station]]> https://www.soliforum.com/post/60871/#p60871 Innovative? Organised? Haaahhhhhhh!
Wobbly glass desk plus wires everywhere.
Just picture spaghetti and you'll have a good idea of my setup tongue

]]> Mon, 21 Jul 2014 11:55:50 +0000 https://www.soliforum.com/post/60871/#p60871 <![CDATA[Show off your printing station]]> https://www.soliforum.com/post/60798/#p60798 With the 3D printer, computer to run RH, plus all the reels of filament and tools/spares involved in running a 3D printer, the whole setup can consume quite a bit of space.

Post a photo here of your innovative/organised setup.

I have 2 SD3s, and a PC (plus monitor/KB/mouse) and a laptop to run them. I am looking to build a bespoke printing station (on wheels), so I am looking for clever, space saving ideas.

Is it a bad idea to have electronics or rolls of filament above the printers due to heat? Both printers have covers.

]]> Sun, 20 Jul 2014 11:29:12 +0000 https://www.soliforum.com/post/60798/#p60798