1

Topic: Sanguinololu Driver?

I have a borrowed Sang and I cannot find the driver on Soliwiki. I am certain since SD switched to the abominable Printrboard, they would no longer have it on their site.

Anyone have the link bookmarked? Please?
Thank you for your help in advance smile

Printit Mason and Printit Horizon printers
Multiple SD2s- Bulldog XL, E3D v5/v6/Lite6, Volcano, Hobb Goblin, Titan, .9 motor, Lawsy carriages, direct Y drive, fishing line...the list goes on
Filawinder and Filastruder #1870.....worth every penny!

2

Re: Sanguinololu Driver?

It's been a while since I used a Sanguino board, but AFAIK the covers everything you need:
http://www.soliwiki.com/Updating_Solidoodle_Firmware

3 (edited by AZERATE 2014-03-23 16:10:56)

Re: Sanguinololu Driver?

ok. Driver was successfully installed, but no lights or fans. Everything else seems in the up and up as I confirmed with some manual commands in RH.
Any ideas?

Edit: Lights and fans are good. I had +/- reversed. *stupid*

Printit Mason and Printit Horizon printers
Multiple SD2s- Bulldog XL, E3D v5/v6/Lite6, Volcano, Hobb Goblin, Titan, .9 motor, Lawsy carriages, direct Y drive, fishing line...the list goes on
Filawinder and Filastruder #1870.....worth every penny!