<![CDATA[SoliForum - 3D Printing Community — Sanguinololu Driver?]]> https://www.soliforum.com/topic/5936/sanguinololu-driver/ Sun, 23 Mar 2014 14:23:47 +0000 PunBB <![CDATA[Re: Sanguinololu Driver?]]> https://www.soliforum.com/post/52740/#p52740 ok. Driver was successfully installed, but no lights or fans. Everything else seems in the up and up as I confirmed with some manual commands in RH.
Any ideas?

Edit: Lights and fans are good. I had +/- reversed. *stupid*

]]> Sun, 23 Mar 2014 14:23:47 +0000 https://www.soliforum.com/post/52740/#p52740 <![CDATA[Re: Sanguinololu Driver?]]> https://www.soliforum.com/post/52723/#p52723 It's been a while since I used a Sanguino board, but AFAIK the covers everything you need:
http://www.soliwiki.com/Updating_Solidoodle_Firmware

]]> Sun, 23 Mar 2014 00:49:02 +0000 https://www.soliforum.com/post/52723/#p52723 <![CDATA[Sanguinololu Driver?]]> https://www.soliforum.com/post/52720/#p52720 I have a borrowed Sang and I cannot find the driver on Soliwiki. I am certain since SD switched to the abominable Printrboard, they would no longer have it on their site.

Anyone have the link bookmarked? Please?
Thank you for your help in advance smile

]]> Sat, 22 Mar 2014 23:16:40 +0000 https://www.soliforum.com/post/52720/#p52720