1 Topic by michaudtime

  • michaudtime
  • Member
  • Offline
  • From: Anchorage, Alaska
  • Registered: 2013-10-18
  • Posts: 92

Topic: Odd post park issue

Hey guys, having a little problem after I finish a print, the head go back to the park position and the bed drops 50mm.  Once the bed goes down my head decides to say F U and tries to go to the opposite corner... what would cause this?  It's been doing it since I swapped out the laptop I was using for my netbook.  Thanks for the help!

Solidoodle 3, Bulldog XL Direct Drive, Well Nut for Z axis, borosilicate glass, E3D V6 Hot end, Custom Encloser, Lawsy Carriages with Linear Bearings and Polished 8mm Chrome rods.

2 Reply by Hazer

  • Hazer
  • Hazer
  • Member
  • Offline
  • Registered: 2013-07-19
  • Posts: 478

Re: Odd post park issue

If you are using Repetier:

In your Config-->Printer Settings-->Printer Tab

There is a Park Position and a checkbox to enable it after Job/Kill. The X and Y settings are absolute, and the Z setting is relative (as in if Z=0, the bed will not move at all after the print). This Park Position is added to the gcode when you Slicer inside RH.

Chuck Bittner is a quadriplegic gamer who is petitioning the major console developers to include internal button remapping in all console games. You can help.
Sign Chuck Bittners petition