SoliForum - 3D Printing Community — Odd post park issue

Re: Odd post park issue

null@example.com (Hazer) — Sun, 16 Feb 2014 12:49:35 +0000

If you are using Repetier:

In your Config-->Printer Settings-->Printer Tab

There is a Park Position and a checkbox to enable it after Job/Kill. The X and Y settings are absolute, and the Z setting is relative (as in if Z=0, the bed will not move at all after the print). This Park Position is added to the gcode when you Slicer inside RH.

Odd post park issue

null@example.com (michaudtime) — Sun, 16 Feb 2014 08:48:09 +0000

Hey guys, having a little problem after I finish a print, the head go back to the park position and the bed drops 50mm. Once the bed goes down my head decides to say F U and tries to go to the opposite corner... what would cause this? It's been doing it since I swapped out the laptop I was using for my netbook. Thanks for the help!