1 Topic by gathem

  • gathem
  • Newbie
  • Offline
  • Registered: 2013-03-26
  • Posts: 9

Topic: Repeteir host eprom settings on mac

I was trying to adjust the flow rate settings but was surprised to see the eprom settings list is empty : /
Any ideas? I checked and I am updated to the latest version of RH and I am running it from my HD (not from a mounted drive)

2 Reply by bpbusch

  • bpbusch
  • Newbie
  • Offline
  • From: Astoria, NY
  • Registered: 2013-12-01
  • Posts: 3

Re: Repeteir host eprom settings on mac

As of 12/2013 you have to enter the G-Code manually in the Print Panel page.

3 Reply by ronsii (edited by ronsii 2013-12-09 07:29:12)

  • ronsii
  • Member
  • Offline
  • From: PNW
  • Registered: 2012-10-28
  • Posts: 1,723

Re: Repeteir host eprom settings on mac

OSX has always had a problem with the eeprom values.

Here is a list of g/m codes ---> http://reprap.org/wiki/G-code

use m92 for setting axe step value ie... 'M92 E xxx'  make sure to use caps wink 'E' is for the extruder stepper/axis

then you can use M500 to save the settings in eeprom
and M501 to read them
and M502 to revert them to factory