<![CDATA[SoliForum - 3D Printing Community — Repeteir host eprom settings on mac]]> https://www.soliforum.com/topic/2850/repeteir-host-eprom-settings-on-mac/ Mon, 09 Dec 2013 07:28:13 +0000 PunBB <![CDATA[Re: Repeteir host eprom settings on mac]]> https://www.soliforum.com/post/43671/#p43671 OSX has always had a problem with the eeprom values.

Here is a list of g/m codes ---> http://reprap.org/wiki/G-code

use m92 for setting axe step value ie... 'M92 E xxx'  make sure to use caps wink 'E' is for the extruder stepper/axis

then you can use M500 to save the settings in eeprom
and M501 to read them
and M502 to revert them to factory

]]> Mon, 09 Dec 2013 07:28:13 +0000 https://www.soliforum.com/post/43671/#p43671 <![CDATA[Re: Repeteir host eprom settings on mac]]> https://www.soliforum.com/post/43661/#p43661 As of 12/2013 you have to enter the G-Code manually in the Print Panel page.

]]> Mon, 09 Dec 2013 04:10:57 +0000 https://www.soliforum.com/post/43661/#p43661 <![CDATA[Repeteir host eprom settings on mac]]> https://www.soliforum.com/post/26770/#p26770 I was trying to adjust the flow rate settings but was surprised to see the eprom settings list is empty : /
Any ideas? I checked and I am updated to the latest version of RH and I am running it from my HD (not from a mounted drive)

]]> Tue, 18 Jun 2013 02:57:55 +0000 https://www.soliforum.com/post/26770/#p26770