1 Topic by coleke

  • coleke
  • coleke
  • Member
  • Offline
  • Registered: 2012-08-07
  • Posts: 166

Topic: PID calibration on Mac RH- blank EEPROM config page

So I ended up replacing my hot end after the wire finally broke at the ceramic, settled on the qu-bd part with 3w resistor. The guide was awesome, but unfortunately when I brought up EEPROM config page on RH, it was a blank page with no buttons. Do I have RH installed correctly? It has been working great for everything but the config page. Any other Mac Repetier-Host users out there with the same issue?

Grand Rapids, Michigan
SD2 with Sanguinololu board, glass bed mod, E3d_v5 bowden version hotend (currently direct drive), Lawsy Mk5 jigsaw replacement, octopi printserver, drv8825(tiny troubles)

2 Reply by lawsy

  • lawsy
  • Moderator
  • Offline
  • Registered: 2012-08-13
  • Posts: 1,220

Re: PID calibration on Mac RH- blank EEPROM config page

As far as I know this is a known issue with the Mac version. You still can use a g-code command to store the settings. You can test if it stored by resetting the printer, as the blurb that it spits out in the log should have the new values.

lawsy's Website

3 Reply by coleke

  • coleke
  • coleke
  • Member
  • Offline
  • Registered: 2012-08-07
  • Posts: 166

Re: PID calibration on Mac RH- blank EEPROM config page

Cool- thank you.

Grand Rapids, Michigan
SD2 with Sanguinololu board, glass bed mod, E3d_v5 bowden version hotend (currently direct drive), Lawsy Mk5 jigsaw replacement, octopi printserver, drv8825(tiny troubles)

4 Reply by nickythegreek

  • nickythegreek
  • Member
  • Offline
  • Registered: 2012-11-18
  • Posts: 673

Re: PID calibration on Mac RH- blank EEPROM config page

Example of mcode writing/saving without the EEPROM setting screen here:
http://www.soliforum.com/post/13352/#p13352