https://www.soliforum.com/topic/1659/pid-calibration-on-mac-rh-blank-eeprom-config-page/ Tue, 12 Mar 2013 14:46:36 +0000 PunBB https://www.soliforum.com/post/16138/#p16138 Example of mcode writing/saving without the EEPROM setting screen here:
http://www.soliforum.com/post/13352/#p13352

]]> Tue, 12 Mar 2013 14:46:36 +0000 https://www.soliforum.com/post/16138/#p16138 https://www.soliforum.com/post/16136/#p16136 Cool- thank you.

]]> Tue, 12 Mar 2013 14:34:10 +0000 https://www.soliforum.com/post/16136/#p16136 https://www.soliforum.com/post/15888/#p15888 As far as I know this is a known issue with the Mac version. You still can use a g-code command to store the settings. You can test if it stored by resetting the printer, as the blurb that it spits out in the log should have the new values.

]]> Sun, 10 Mar 2013 21:34:01 +0000 https://www.soliforum.com/post/15888/#p15888 https://www.soliforum.com/post/15869/#p15869 So I ended up replacing my hot end after the wire finally broke at the ceramic, settled on the qu-bd part with 3w resistor. The guide was awesome, but unfortunately when I brought up EEPROM config page on RH, it was a blank page with no buttons. Do I have RH installed correctly? It has been working great for everything but the config page. Any other Mac Repetier-Host users out there with the same issue?

]]> Sun, 10 Mar 2013 19:57:40 +0000 https://www.soliforum.com/post/15869/#p15869