1 Topic by Fatal-Flaw

  • Fatal-Flaw
  • Newbie
  • Offline
  • Registered: 2015-08-22
  • Posts: 5

Topic: Davinci duo 2.0 think extruder 1 not heating

My extruder 1 worked for 2 days and then stopped heating. I have seen on another topic possible causes. I tested the temp gauge with a heat gun and it worked. 3 red leds on motherboard for the resistor fuses. So must be 5he heat cartridge.

Does anyone know where I can get these from and how to replace them? I am new to 3d printing g btw so detailed set of instructions would be awesome.

Many thanks in advance!

2 Reply by Fatal-Flaw

  • Fatal-Flaw
  • Newbie
  • Offline
  • Registered: 2015-08-22
  • Posts: 5

Re: Davinci duo 2.0 think extruder 1 not heating

Extruder 1 still won't heat up. I can't find a solution. I don't need to replace the module as extruder 2 heats up fine. Was thinking get a similar replacement with the 2 wires attached like the original?

3 Reply by Fatal-Flaw

  • Fatal-Flaw
  • Newbie
  • Offline
  • Registered: 2015-08-22
  • Posts: 5

Re: Davinci duo 2.0 think extruder 1 not heating

I got a brand new extruder duo replacement for around £100 and still had the problem. So company helping me with this said sounds like you need new heating element that was like £10 off XYZ. got it today and find got 2 new 1s on the new extruder package and no instructions for how to fit it.
Does anyone know what I need to do or iv wasted over £600 including my attempts to get replacement parts working getting scrapped...