1 Topic by shields1.as

  • shields1.as
  • Member
  • Offline
  • Registered: 2014-09-02
  • Posts: 398

Topic: Layer separation

Finally got everything calibrated and level. Got the nozzle putting out the right amount and the bed perfected. I have an enclosure but for some reason I'm now getting layer separation. It's like after all that work now something new wants to pop up. Not sure if the room is just too chilly or what. Do I need higher extruder temp? I'm at 195 c and 90 c on the glass bed

2 Reply by wardjr

  • wardjr
  • wardjr
  • Moderator
  • Offline
  • From: Minnesota
  • Registered: 2013-06-10
  • Posts: 5,624

Re: Layer separation

Stock hotend?
ABS?
195 seems low

Printit Industries Model 8.10 fully enclosed CoreXY, Chamber heat
3-SD3's & a Workbench all fully enclosed, RH-Slic3r Win7pro, E3D V6, Volcano & Cyclops Hot End
SSR/500W AC Heated Glass Bed, Linear bearings on SS rods. Direct Drive Y-axis, BulldogXL
Thanks to all for your contributions

wardjr's Website

3 Reply by shields1.as

  • shields1.as
  • Member
  • Offline
  • Registered: 2014-09-02
  • Posts: 398

Re: Layer separation

E3dv6 hot end. I'm probably just running too low with 195. I'll try again tomorrow.



wardjr wrote:

Stock hotend?
ABS?
195 seems low

4 Reply by shields1.as

  • shields1.as
  • Member
  • Offline
  • Registered: 2014-09-02
  • Posts: 398

Re: Layer separation

Yeah abs

5 Reply by wardjr

  • wardjr
  • wardjr
  • Moderator
  • Offline
  • From: Minnesota
  • Registered: 2013-06-10
  • Posts: 5,624

Re: Layer separation

Try 240-245

Printit Industries Model 8.10 fully enclosed CoreXY, Chamber heat
3-SD3's & a Workbench all fully enclosed, RH-Slic3r Win7pro, E3D V6, Volcano & Cyclops Hot End
SSR/500W AC Heated Glass Bed, Linear bearings on SS rods. Direct Drive Y-axis, BulldogXL
Thanks to all for your contributions

wardjr's Website