<![CDATA[SoliForum - 3D Printing Community — Layer separation]]> https://www.soliforum.com/topic/8997/layer-separation/ Sat, 03 Jan 2015 01:34:45 +0000 PunBB <![CDATA[Re: Layer separation]]> https://www.soliforum.com/post/77290/#p77290 Try 240-245

]]> Sat, 03 Jan 2015 01:34:45 +0000 https://www.soliforum.com/post/77290/#p77290 <![CDATA[Re: Layer separation]]> https://www.soliforum.com/post/77289/#p77289 Yeah abs

]]> Sat, 03 Jan 2015 01:27:28 +0000 https://www.soliforum.com/post/77289/#p77289 <![CDATA[Re: Layer separation]]> https://www.soliforum.com/post/77288/#p77288 E3dv6 hot end. I'm probably just running too low with 195. I'll try again tomorrow.



wardjr wrote:

Stock hotend?
ABS?
195 seems low

]]> Sat, 03 Jan 2015 01:27:16 +0000 https://www.soliforum.com/post/77288/#p77288 <![CDATA[Re: Layer separation]]> https://www.soliforum.com/post/77284/#p77284 Stock hotend?
ABS?
195 seems low

]]> Sat, 03 Jan 2015 01:19:21 +0000 https://www.soliforum.com/post/77284/#p77284 <![CDATA[Layer separation]]> https://www.soliforum.com/post/77282/#p77282 Finally got everything calibrated and level. Got the nozzle putting out the right amount and the bed perfected. I have an enclosure but for some reason I'm now getting layer separation. It's like after all that work now something new wants to pop up. Not sure if the room is just too chilly or what. Do I need higher extruder temp? I'm at 195 c and 90 c on the glass bed

]]> Sat, 03 Jan 2015 00:42:01 +0000 https://www.soliforum.com/post/77282/#p77282