1 Topic by Nerfz

  • Nerfz
  • Member
  • Offline
  • Registered: 2013-02-18
  • Posts: 43

Topic: 17 Nema Hybrid extruder motor?

So putting an E3D v6 in and the mounts for it come out a little to far no bigge I will just move the little feeder on the end of the motor over right? Wrong the bolt stripped out.... So I was going to but a Nema 17 hybrid there instead (Have the parts from another project) But it is a 6 wire.. Is there anyway to wire it up to a 4 pin?

Thanks..

SD4, Glass bed,(Soon to have) E3D v6, MK5 extruder

2 Reply by satman49

  • satman49
  • Member
  • Offline
  • From: virginia
  • Registered: 2012-12-28
  • Posts: 867

Re: 17 Nema Hybrid extruder motor?

Take a look  at this  http://reprap.org/wiki/Stepper_wiring

SD3, E3D hotend,linear bearing on x/y axis',pillow block bearing on y conneting rod, ball bearngs on front y axis, fan on y stepper motor.

3 Reply by Tin Falcon

  • Tin Falcon
  • Tin Falcon
  • Member
  • Offline
  • From: New Jersey, USA
  • Registered: 2014-08-01
  • Posts: 2,424

Re: 17 Nema Hybrid extruder motor?

Should not be a problem. Pull up the datasheet on your motor.
there are two ways to wire it either way you only use 4 wires, .
here is the data sheet from  my motors from another project to give you an idea.

http://www.interinar.com/public_docs/PK266-02A.pdf
Tin

Soliddoodle 4 stock w glass bed------Folger Tech Prusa 2020 upgraded to and titan /aero extruder mirror bed
FT5 with titan/ E3D Aero------MP mini select w glass bed
MP Utimate maker pro-W bondtech extruder
Marlin/Repetier Host/ Slic3r and Cura