<![CDATA[SoliForum - 3D Printing Community — 17 Nema Hybrid extruder motor?]]> https://www.soliforum.com/topic/8830/17-nema-hybrid-extruder-motor/ Sat, 20 Dec 2014 21:02:44 +0000 PunBB <![CDATA[Re: 17 Nema Hybrid extruder motor?]]> https://www.soliforum.com/post/75991/#p75991 Should not be a problem. Pull up the datasheet on your motor.
there are two ways to wire it either way you only use 4 wires, .
here is the data sheet from  my motors from another project to give you an idea.

http://www.interinar.com/public_docs/PK266-02A.pdf
Tin

]]> Sat, 20 Dec 2014 21:02:44 +0000 https://www.soliforum.com/post/75991/#p75991 <![CDATA[Re: 17 Nema Hybrid extruder motor?]]> https://www.soliforum.com/post/75990/#p75990 Take a look  at this  http://reprap.org/wiki/Stepper_wiring

]]> Sat, 20 Dec 2014 20:55:46 +0000 https://www.soliforum.com/post/75990/#p75990 <![CDATA[17 Nema Hybrid extruder motor?]]> https://www.soliforum.com/post/75986/#p75986 So putting an E3D v6 in and the mounts for it come out a little to far no bigge I will just move the little feeder on the end of the motor over right? Wrong the bolt stripped out.... So I was going to but a Nema 17 hybrid there instead (Have the parts from another project) But it is a 6 wire.. Is there anyway to wire it up to a 4 pin?

Thanks..

]]> Sat, 20 Dec 2014 20:14:30 +0000 https://www.soliforum.com/post/75986/#p75986