1 Topic by slimstar2

  • slimstar2
  • slimstar2
  • Member
  • Offline
  • From: North Providence Rhode Island
  • Registered: 2014-03-28
  • Posts: 144

Topic: Panelolu2 and Solidoodle 3

Hello to all, I am trying to get my SD3 with solidoodle Rev 3 MB to work with Panelolu2 .Can anyone help ?

SD3, RAMPS 1.4, Lawsy's carriages modified by me, 2 SSRs, E3D V6, 2 Power supplies, Independent monitoring of both power supplies (amps and volts) also extruder and bed temps, Blue Tooth connectivity, bearings in all axis & rotational points, Y axis direct drive.  Remotely controlled power box on / off . Gecko Tec build plate . Renamed FrankenDoodle

2 Reply by renee

  • renee
  • Member
  • Offline
  • Registered: 2014-01-29
  • Posts: 47

Re: Panelolu2 and Solidoodle 3

Hi Bill

There isn't enough information here to really help you. My Panelolu2 arrived yesterday afternoon. I followed the instructions on these two pages and had it working last night.

Marlin Setup:
http://blog.think3dprint3d.com/2013/04/ … board.html

Disabling JTAG on Printrboard:
http://blog.think3dprint3d.com/2012/07/ … board.html

Once I had my firmware configured and compiled ( there is a lot of info online already for this ) I was ready to begin the necessary hardware changes. If you are thinking you tried everything you probably didn't populate the 14 pin EXP1 header on your Printrboard ( next to the ICSP header ).

So have a look at those pages.. maybe think about describing your current situation a bit better and you might have a chance of getting your Panelolu2 working.