<![CDATA[SoliForum - 3D Printing Community — Panelolu2 and Solidoodle 3]]> https://www.soliforum.com/topic/6086/panelolu2-and-solidoodle-3/ Thu, 10 Apr 2014 18:51:20 +0000 PunBB <![CDATA[Re: Panelolu2 and Solidoodle 3]]> https://www.soliforum.com/post/53935/#p53935 Hi Bill

There isn't enough information here to really help you. My Panelolu2 arrived yesterday afternoon. I followed the instructions on these two pages and had it working last night.

Marlin Setup:
http://blog.think3dprint3d.com/2013/04/ … board.html

Disabling JTAG on Printrboard:
http://blog.think3dprint3d.com/2012/07/ … board.html

Once I had my firmware configured and compiled ( there is a lot of info online already for this ) I was ready to begin the necessary hardware changes. If you are thinking you tried everything you probably didn't populate the 14 pin EXP1 header on your Printrboard ( next to the ICSP header ).

So have a look at those pages.. maybe think about describing your current situation a bit better and you might have a chance of getting your Panelolu2 working.

]]> Thu, 10 Apr 2014 18:51:20 +0000 https://www.soliforum.com/post/53935/#p53935 <![CDATA[Panelolu2 and Solidoodle 3]]> https://www.soliforum.com/post/53763/#p53763 Hello to all, I am trying to get my SD3 with solidoodle Rev 3 MB to work with Panelolu2 .Can anyone help ?

]]> Tue, 08 Apr 2014 18:25:00 +0000 https://www.soliforum.com/post/53763/#p53763