1 Topic by Gomisan

  • Gomisan
  • Gomisan
  • Member
  • Offline
  • From: Adelaide, Australia
  • Registered: 2013-07-29
  • Posts: 266

Topic: Anyone seen this Teflon nozzle modification

It looks like a Teflon coating has been applied to the brass nozzle, stopping molten plastic from building up on it.

Gomisan's Website

2 Reply by IanJohnson

  • IanJohnson
  • Moderator
  • Offline
  • Registered: 2012-08-07
  • Posts: 2,815

Re: Anyone seen this Teflon nozzle modification

Just don't run it over 315C with an E3D, especially if you have birds around.

3 Reply by Gomisan

  • Gomisan
  • Gomisan
  • Member
  • Offline
  • From: Adelaide, Australia
  • Registered: 2013-07-29
  • Posts: 266

Re: Anyone seen this Teflon nozzle modification

I'm guessing Teflon off gasses some nasty stuff at high temps then?

Gomisan's Website