<![CDATA[SoliForum - 3D Printing Community — Anyone seen this Teflon nozzle modification]]> https://www.soliforum.com/topic/4199/anyone-seen-this-teflon-nozzle-modification/ Fri, 11 Oct 2013 00:15:38 +0000 PunBB <![CDATA[Re: Anyone seen this Teflon nozzle modification]]> https://www.soliforum.com/post/38643/#p38643 I'm guessing Teflon off gasses some nasty stuff at high temps then?

]]> Fri, 11 Oct 2013 00:15:38 +0000 https://www.soliforum.com/post/38643/#p38643 <![CDATA[Re: Anyone seen this Teflon nozzle modification]]> https://www.soliforum.com/post/38640/#p38640 Just don't run it over 315C with an E3D, especially if you have birds around.

]]> Fri, 11 Oct 2013 00:10:15 +0000 https://www.soliforum.com/post/38640/#p38640 <![CDATA[Anyone seen this Teflon nozzle modification]]> https://www.soliforum.com/post/38638/#p38638

It looks like a Teflon coating has been applied to the brass nozzle, stopping molten plastic from building up on it.

]]> Thu, 10 Oct 2013 23:54:13 +0000 https://www.soliforum.com/post/38638/#p38638