1 Topic by kajakmannen

  • kajakmannen
  • Newbie
  • Offline
  • Registered: 2013-07-05
  • Posts: 8

Topic: Solidworks 3D assembly of a Solidoodle 3 parinter or at least the axis

Hi
I have printed some with my Solidoodle 3 now and the mods continoue big_smile

Are there someone out htere that has a 3D assembly of the Solidoodle 3 printer. I would like to design a hinged arm for the cables out to the extruder so that the cables do not hit the left hand side belt when printing wide.

A 3D assembly would help a lot when doing this.

BR / Kajaken


*******************************
Designer and hobbyist
My parts sofar:
Solidoodle 3 enclosure --> thing:125599 on thingiverse
Nema23 stepper fan mount --> thing:125611 on thingiverse

Kajakmannen. Designer and hobbyist. My parts sofar:
Solidoodle 3 enclosure --> thing:125599 on thingiverse
Nema23 stepper fan mount --> thing:125611 on thingiverse

2 Reply by adrian

  • adrian
  • Member
  • Offline
  • From: Canberra, Australia
  • Registered: 2013-01-15
  • Posts: 1,623

Re: Solidworks 3D assembly of a Solidoodle 3 parinter or at least the axis

You can find a mostly done model here on the forum, can't find the thread right now but you can search for it or someone else will link it.

For the wire -> cable problem, most people did this http://www.thingiverse.com/thing:51134 or a variation (theres a remix or two with longer tongues) or there is the newer cable chains like this http://www.thingiverse.com/thing:104817 again with details in the thread from lawsy on here referenced on the thingiverse page about the extra links needed for an SD3.

Hope that helps a bit..

3 Reply by Hunter Green

  • Hunter Green
  • Hunter Green
  • Member
  • Offline
  • Registered: 2013-03-26
  • Posts: 336

Re: Solidworks 3D assembly of a Solidoodle 3 parinter or at least the axis

If you go the wire guide route, rather than the first URL adrian quoted, use this one: http://www.thingiverse.com/thing:94675   The first one is sized for the SD2, the second one is a remix sized for the SD3.

FlashForge Creator, SketchUp 2013