1 Topic by theman00011

  • theman00011
  • Member
  • Offline
  • Registered: 2013-06-20
  • Posts: 41

Topic: Prints lift partially even after leveling the bed.

So what happened was I moved my SD2 to another area and I think it might have got unleveled while moving. No problem right? Well, that is what I thought but after leveling the bed with a card and double checking it, I did a test print and it was coming up. So I adjusted the Z tab counter-clockwise until it started sticking. But it only stuck on one side even after re-leveling. Any ideas as to how to fix this? It was working just fine until I moved it.

2 Reply by ronsii

  • ronsii
  • Member
  • Offline
  • From: PNW
  • Registered: 2012-10-28
  • Posts: 1,723

Re: Prints lift partially even after leveling the bed.

Have you cleaned the bed kapton with anything recently?

3 Reply by theman00011

  • theman00011
  • Member
  • Offline
  • Registered: 2013-06-20
  • Posts: 41

Re: Prints lift partially even after leveling the bed.

I haven't got my headed bed in the mail yet so I am actually using just the acrylic bed alone. I cleaned it with acetone a few days ago but that is it.