26 Reply by 2n2r5 (edited by 2n2r5 2013-06-22 12:41:47)

  • 2n2r5
  • 2n2r5
  • Member
  • Offline
  • From: Frederick, MD
  • Registered: 2013-05-09
  • Posts: 1,208

Re: Fastest Solidoodle in the west (or east...)

elmoret wrote:

What are the print speeds/settings you guys use? I've been using this as highspeed:

Maximum Feedrates: 500/500/5/45 (X/Y/Z/E)
Maximum Acceleration: 9000 9000 100 10000
Maximum X-Y Jerk: 20

Perimeters: 150mm/s
Infill: 175mm/s
Travel: 175mm/s

Filament: MG94 made on a Filastruder, printed at 200C.

I doubt it actually gets to those speeds on most moves, though.

You guys?


Maximum Feedrates: 500/500/5/60 (X/Y/Z/E)
Maximum Acceleration: 9000 9000 100 10000
Maximum X-Y Jerk: 20

Feed Rate: 129%
                  Setting (actual with feed rate adjustment)
Perimeters: 120mm/s ( 154.8 mm/s)
small perimeters: 100mm/s (129 mm/s)
external perimeters: 80mm/s (103.2 mm/s)
infill: 110mm/s  (141.9 mm/s)
top solid: 80mm/s (103.2 mm/s)
bridges 80mm/s (103.2 mm/s)
gap fill: 30mm/s (38.7 mm/s)

Travel: 150mm/s (193.5 mm/s)

Not sure what kind of plastic this is. It is natural and on a solidoodle reel but I got it from Tim.

Printrbot hot end @ 225C w/ fan

Sorry about the clicking in the video. I had my scraper on top of my case.

SD3 w/ mods:
Glass bed with QU-BD heat pad upgrade, threadless ballscrew w/ 8mm smooth rod, spectra line belt replacement, lawsy MK5 extruder, Lawsy replacement carriage, E3D hotend, Ramps 1.4 w/ reprap discount controller, DRV8825 drivers, 12v 30A PS, Acrylic case, Overkill Y-idlers, Filament alarm, Extruder fan + more.

2n2r5's Website