1 Topic by chanhdat

  • chanhdat
  • Newbie
  • Offline
  • Registered: 2013-06-18
  • Posts: 2

Topic: Replacing extruder

Not long ago I encountered a hot clog, couldn't take the hotend separated from the PEEK plastic barrel. So I decided to spare me some trouble by getting a new extruder from Solidoodle.
After carefully (well, not so much) putting everything back together with the new extruder, I get a new problem.

Error:0
: Extruder switched off. MINTEMP triggered !
Error:Printer stopped deu to errors. Fix the error and use M999 to restart!. (Temperature is reset. Set it before restarting)

Anyone has any ideas to solve this?

Thank you a lot in advance.

2 Reply by 2n2r5

  • 2n2r5
  • 2n2r5
  • Member
  • Offline
  • From: Frederick, MD
  • Registered: 2013-05-09
  • Posts: 1,208

Re: Replacing extruder

Your thermistor for the extruder is either not plugged in or the or the wires have come loose from the connector. Check to make sure the wires go all the way up the insulation. It's the blue connector.

SD3 w/ mods:
Glass bed with QU-BD heat pad upgrade, threadless ballscrew w/ 8mm smooth rod, spectra line belt replacement, lawsy MK5 extruder, Lawsy replacement carriage, E3D hotend, Ramps 1.4 w/ reprap discount controller, DRV8825 drivers, 12v 30A PS, Acrylic case, Overkill Y-idlers, Filament alarm, Extruder fan + more.

2n2r5's Website

3 Reply by chanhdat

  • chanhdat
  • Newbie
  • Offline
  • Registered: 2013-06-18
  • Posts: 2

Re: Replacing extruder

Thanks very much, just realize that one of the wire went loose, so I replace the thermistor with the one of the old extruder. It works now!