<![CDATA[SoliForum - 3D Printing Community — Replacing extruder]]> https://www.soliforum.com/topic/2854/replacing-extruder/ Tue, 18 Jun 2013 12:25:46 +0000 PunBB <![CDATA[Re: Replacing extruder]]> https://www.soliforum.com/post/26821/#p26821 Thanks very much, just realize that one of the wire went loose, so I replace the thermistor with the one of the old extruder. It works now!

]]> Tue, 18 Jun 2013 12:25:46 +0000 https://www.soliforum.com/post/26821/#p26821 <![CDATA[Re: Replacing extruder]]> https://www.soliforum.com/post/26808/#p26808 Your thermistor for the extruder is either not plugged in or the or the wires have come loose from the connector. Check to make sure the wires go all the way up the insulation. It's the blue connector.

]]> Tue, 18 Jun 2013 10:41:20 +0000 https://www.soliforum.com/post/26808/#p26808 <![CDATA[Replacing extruder]]> https://www.soliforum.com/post/26799/#p26799 Not long ago I encountered a hot clog, couldn't take the hotend separated from the PEEK plastic barrel. So I decided to spare me some trouble by getting a new extruder from Solidoodle.
After carefully (well, not so much) putting everything back together with the new extruder, I get a new problem.

Error:0
: Extruder switched off. MINTEMP triggered !
Error:Printer stopped deu to errors. Fix the error and use M999 to restart!. (Temperature is reset. Set it before restarting)

Anyone has any ideas to solve this?

Thank you a lot in advance.

]]> Tue, 18 Jun 2013 09:54:37 +0000 https://www.soliforum.com/post/26799/#p26799