Topic: PID autotune
I just ran the gcode for PID autotune in RH. Where exactly do my P, I, D values show up? I can't seem to locate them anywhere in RH. Thank you!
Re: PID autotune
Ahh... I think its configure button top left. Then eeprom something.
Re: PID autotune
Still no luck! I entered the code in the gcode editor this time, and hit run job. See if this works. Before I ran it from the manual control tab, but there was my last print job still left in the editor, so maybe this was a problem.
Re: PID autotune
I began my PID tuning process at Soliwiki. It says the values will be printed out at the bottom of my screen, but they are nowhere to be found. I can tell from the temperature curve window that it's cycling for five times. I just can't seem to find where these values are stored. Thanks.
Re: PID autotune
You might need to scroll up on the message window at the bottom of the screen to find where the values printed.
Re: PID autotune
You may have to expand your command log window in the manual control tab. If you move your mouse to where the arrow is in the drawing, the cursor will change to a line grab cursor. Drag it up to show the window.
SD2
E3D V6
MK5 V6
E3D V6
MK5 V6
Re: PID autotune
Gordym, that did the trick. Thank you!