SoliForum - 3D Printing Community — PID autotune

Re: PID autotune

null@example.com (Briggs) — Wed, 08 May 2013 17:11:34 +0000

Gordym, that did the trick. Thank you!

Re: PID autotune

null@example.com (Gordym) — Wed, 08 May 2013 16:28:05 +0000

You may have to expand your command log window in the manual control tab. If you move your mouse to where the arrow is in the drawing, the cursor will change to a line grab cursor. Drag it up to show the window.

Re: PID autotune

null@example.com (wilheldp) — Wed, 08 May 2013 16:18:34 +0000

You might need to scroll up on the message window at the bottom of the screen to find where the values printed.

Re: PID autotune

null@example.com (Briggs) — Wed, 08 May 2013 16:15:54 +0000

I began my PID tuning process at Soliwiki. It says the values will be printed out at the bottom of my screen, but they are nowhere to be found. I can tell from the temperature curve window that it's cycling for five times. I just can't seem to find where these values are stored. Thanks.

Re: PID autotune

null@example.com (elmoret) — Wed, 08 May 2013 16:11:40 +0000

http://www.soliwiki.com/PID_tuning

Re: PID autotune

null@example.com (Briggs) — Wed, 08 May 2013 16:04:52 +0000

Still no luck! I entered the code in the gcode editor this time, and hit run job. See if this works. Before I ran it from the manual control tab, but there was my last print job still left in the editor, so maybe this was a problem.

Re: PID autotune

null@example.com (Smitty505000) — Wed, 08 May 2013 15:56:51 +0000

Ahh... I think its configure button top left. Then eeprom something.

PID autotune

null@example.com (Briggs) — Wed, 08 May 2013 15:42:27 +0000

I just ran the gcode for PID autotune in RH. Where exactly do my P, I, D values show up? I can't seem to locate them anywhere in RH. Thank you!