1 Topic by pirvan

  • pirvan
  • pirvan
  • Member
  • Offline
  • From: San Francisco
  • Registered: 2013-03-27
  • Posts: 1,797

Topic: KiSSlicer profile for SD3

Does any one use the KiSSlicer?

I'm using the 1.1.0 Release Candidate, and it's very good at slicing models, especially organic looking ones.  I found it can accurately slice objects that Slic3r can't handle at all.  Plus it's fast as hell.

My problems is that I"m still a total newb, and I don't know how to properly set it up with the correct G-Codes.

Mind you, I was able to import and print Gcode generated by KiSSlicer, but I'm not sure I have all the correct settings, especially for things like cooling, flow, speed, ABS settings, PLA settings, etc.

If anyone that's been doing this and using the KiSSlicer for a while has any input or better yet a SoliDoodle profile for it, it would be greatly appreciated.


Thanks,

To print or, 3D print, that is the question...
SD3 printer w/too many mods,  Printrbot Simple Maker Ed.,  FormLabs Form 1+
AnyCubic Photon, Shining 3D EinScan-S & Atlas 3D scanners...
...and too much time on my hands.

2 Reply by DePartedPrinter

  • DePartedPrinter
  • Moderator
  • Offline
  • From: Colorado
  • Registered: 2012-08-14
  • Posts: 1,478

Re: KiSSlicer profile for SD3

Check this out for some of the settings people have been using. Since you have an SD3 you will obviously need to set the bed size larger than in these settings ( I think most are for SD2). Everything else should be the same.

http://www.soliforum.com/topic/348/kisslicer/

SD2 with E3D, SD Press, Form 1+
Filastruder
NYLON (taulman): http://www.soliforum.com/topic/466/nylon/