1 Topic by Schieggster

  • Schieggster
  • Member
  • Offline
  • From: Houston, TX
  • Registered: 2013-02-19
  • Posts: 214

Topic: X Traversing seems to be jumpy

I had been printing for a while last night, and after one of the prints I went to check the level of the bed. So I manually moved the Print head from Right to Left along the back of the bed, and even though I was choosing 100mm Movement (Repetier-host) it seemed to jump across the bed in 10mm increments.

When I started a print, the X seemed to move fine...

Could my print head have been to close? or was my X motor a bit warm?

2 Reply by jjcuff1

  • jjcuff1
  • Member
  • Offline
  • Registered: 2012-10-18
  • Posts: 253

Re: X Traversing seems to be jumpy

Maybe you had a command waiting from pause or prior print that did not clear, so it executed that first

SD2 owner- Surestepr, filament holder,QUBD servo and heaters, glass bed
Print for fun and for parts for my sports cars
current car is 88 IROC

3 Reply by Schieggster

  • Schieggster
  • Member
  • Offline
  • From: Houston, TX
  • Registered: 2013-02-19
  • Posts: 214

Re: X Traversing seems to be jumpy

jjcuff1 wrote:

Maybe you had a command waiting from pause or prior print that did not clear, so it executed that first

Ahh, I'll have to look when I get off of work. I just wanted to see if this has happened to anyone before, of if I'm just dumb