<![CDATA[SoliForum - 3D Printing Community — X Traversing seems to be jumpy]]> https://www.soliforum.com/topic/1732/x-traversing-seems-to-be-jumpy/ Fri, 15 Mar 2013 14:11:59 +0000 PunBB <![CDATA[Re: X Traversing seems to be jumpy]]> https://www.soliforum.com/post/16592/#p16592 jjcuff1 wrote:

Maybe you had a command waiting from pause or prior print that did not clear, so it executed that first

Ahh, I'll have to look when I get off of work. I just wanted to see if this has happened to anyone before, of if I'm just dumb

]]> Fri, 15 Mar 2013 14:11:59 +0000 https://www.soliforum.com/post/16592/#p16592 <![CDATA[Re: X Traversing seems to be jumpy]]> https://www.soliforum.com/post/16591/#p16591 Maybe you had a command waiting from pause or prior print that did not clear, so it executed that first

]]> Fri, 15 Mar 2013 14:05:54 +0000 https://www.soliforum.com/post/16591/#p16591 <![CDATA[X Traversing seems to be jumpy]]> https://www.soliforum.com/post/16585/#p16585 I had been printing for a while last night, and after one of the prints I went to check the level of the bed. So I manually moved the Print head from Right to Left along the back of the bed, and even though I was choosing 100mm Movement (Repetier-host) it seemed to jump across the bed in 10mm increments.

When I started a print, the X seemed to move fine...

Could my print head have been to close? or was my X motor a bit warm?

]]> Fri, 15 Mar 2013 13:27:00 +0000 https://www.soliforum.com/post/16585/#p16585