26 Reply by Tin Falcon

  • Tin Falcon
  • Tin Falcon
  • Member
  • Offline
  • From: New Jersey, USA
  • Registered: 2014-08-01
  • Posts: 2,424

Re: wrong axis movements

So wired endstop as no. Everything moves correctly. However, when I click move to 10mm in rh it moves to 10 and when I issue G1 Z11 it moves backwards ?  X and y move to the correct location when issuing the same gcode command.

OK I have to ask in RH  are you using the arrow above or below  the circle and when you do the g1 Z11 comand does the bed move up or down.

Soliddoodle 4 stock w glass bed------Folger Tech Prusa 2020 upgraded to and titan /aero extruder mirror bed
FT5 with titan/ E3D Aero------MP mini select w glass bed
MP Utimate maker pro-W bondtech extruder
Marlin/Repetier Host/ Slic3r and Cura

27 Reply by Revolution289

  • Revolution289
  • Member
  • Offline
  • Registered: 2015-11-13
  • Posts: 40

Re: wrong axis movements

Using up causes the bed to move down.   So far everything is good now. The manual home position was different from what rh was reporting.

28 Reply by Tin Falcon

  • Tin Falcon
  • Tin Falcon
  • Member
  • Offline
  • From: New Jersey, USA
  • Registered: 2014-08-01
  • Posts: 2,424

Re: wrong axis movements

Using up causes the bed to move down

As it should be  sounds like you have it sorted out.
Tin .

Soliddoodle 4 stock w glass bed------Folger Tech Prusa 2020 upgraded to and titan /aero extruder mirror bed
FT5 with titan/ E3D Aero------MP mini select w glass bed
MP Utimate maker pro-W bondtech extruder
Marlin/Repetier Host/ Slic3r and Cura

29 Reply by Revolution289

  • Revolution289
  • Member
  • Offline
  • Registered: 2015-11-13
  • Posts: 40

Re: wrong axis movements

Sigh i've run into another problem. I was trying to clean my corners to get sharper prints and dialed in extrusion rate and noticed both y belts are loose I tightened them and now when making quick moves it binds and causes skipping.  I dialed the max acceleration back to 3000 should I go back even further?  I also got the ripples to go away but sporadically I get clicking.

30 Reply by Tin Falcon (edited by Tin Falcon 2016-08-14 14:03:00)

  • Tin Falcon
  • Tin Falcon
  • Member
  • Offline
  • From: New Jersey, USA
  • Registered: 2014-08-01
  • Posts: 2,424

Re: wrong axis movements

The belts may be a little too tight now .
And increase the vref  a bit.
adjusting pots can take a little time . and they can be unpredictable.
in my slic3r settings acceleration is set for 1000 mm/sec^2
so probably .

Soliddoodle 4 stock w glass bed------Folger Tech Prusa 2020 upgraded to and titan /aero extruder mirror bed
FT5 with titan/ E3D Aero------MP mini select w glass bed
MP Utimate maker pro-W bondtech extruder
Marlin/Repetier Host/ Slic3r and Cura

31 Reply by Revolution289

  • Revolution289
  • Member
  • Offline
  • Registered: 2015-11-13
  • Posts: 40

Re: wrong axis movements

Unpredictable is a understatement lol. Is there anything else to get sharper corners?