1 Topic by rds12845

  • rds12845
  • Newbie
  • Offline
  • Registered: 2016-05-29
  • Posts: 2

Topic: Help with printing

Using newest Repieter since the original was corrupted. The filaments seem to deposit on the print bed too far apart and don't stick together. They are more like individual strings laid next to each other. The original software worked fine.  I am a newbie so any help would be appreciated

2 Reply by Tin Falcon

  • Tin Falcon
  • Tin Falcon
  • Member
  • Offline
  • From: New Jersey, USA
  • Registered: 2014-08-01
  • Posts: 2,424

Re: Help with printing

Try to find , restore use you old profiles.
where did your settings come from to begin with??
What printer are you using.

Soliddoodle 4 stock w glass bed------Folger Tech Prusa 2020 upgraded to and titan /aero extruder mirror bed
FT5 with titan/ E3D Aero------MP mini select w glass bed
MP Utimate maker pro-W bondtech extruder
Marlin/Repetier Host/ Slic3r and Cura

3 Reply by heartless (edited by heartless 2016-05-31 00:54:43)

  • heartless
  • heartless
  • Member
  • Offline
  • From: Northcentral Wisconsin
  • Registered: 2015-04-08
  • Posts: 2,152

Re: Help with printing

most likely has the wrong nozzle size set in the configuration - their default is a 0.5 - most printers have a 0.4 stock, some smaller

SD4 #1 & #2 - Lawsy carriages, E3D v6, Rumba controller board, mirror bed plate, X motor fan, upgraded PSU & Mica bed heater
SD4 #3 - in the works ~ Folgertech FT-5, rev 1
Printit Industries Beta Tester - Horizon H1