Topic: Hot End Not Heating
My printers hot end was not heating so I checked the voltage of the white leads on my mother board and my multimeter showed no voltage. Has any had this problem?
- scobo
- Member
- Offline
Re: Hot End Not Heating
It's a common problem with the black connectors, they're very poor quality.
I removed mine and soldered the wires together.
Davinci 1.0 with repetier firmware & E3D V6 Lite
Anycubic Photon DLP printer, Einscan-S 3D scanner
Simplify3d, 123D Design, Meshmixer
http://www.thingiverse.com/scobo/designs
Anycubic Photon DLP printer, Einscan-S 3D scanner
Simplify3d, 123D Design, Meshmixer
http://www.thingiverse.com/scobo/designs
Re: Hot End Not Heating
If you're not getting voltage at the motherboard, its not a problem with the connectors. I've recently encountered the same problem as the OP but haven't had a chance to work it through. I read somewhere that it may be a blown inline fuse... they look like a real PIA to replace. This is happening on a 1.0A... is that the same model you have jamp2112?
- scobo
- Member
- Offline
Re: Hot End Not Heating
Ah, didn't spot the bit about the mainboard.
Probably not the connectors then.
Davinci 1.0 with repetier firmware & E3D V6 Lite
Anycubic Photon DLP printer, Einscan-S 3D scanner
Simplify3d, 123D Design, Meshmixer
http://www.thingiverse.com/scobo/designs
Anycubic Photon DLP printer, Einscan-S 3D scanner
Simplify3d, 123D Design, Meshmixer
http://www.thingiverse.com/scobo/designs
Re: Hot End Not Heating
I have a 1.0A How do I fix my printer?
6 2016-03-02 01:36:47 (edited by mark.burton 2016-03-02 01:37:14)
Re: Hot End Not Heating
check the solution in this thread.
http://www.soliforum.com/topic/12398/fu