1 Topic by Cardsin2005

  • Cardsin2005
  • Newbie
  • Offline
  • Registered: 2014-12-30
  • Posts: 8

Topic: Has any one seen this before?

I am was printing a new carriage for the DaVinci and it failed twice in a strange way.

http://soliforum.com/i/?Ng7XbZL.jpg
http://soliforum.com/i/?9VCu06U.jpg

As you can see the X axis all of a sudden starting printing exactly 25mm off. the Y was fine. Both prints did this at almost the exact some or the exact same layer. I also re-sliced it between prints, and even added other prints to the print bed. So I don't know if is an error with the .STL or if my printer is messing it up. What do you guys think?

2 Reply by mpoffo

  • mpoffo
  • Member
  • Offline
  • From: Milwaukee WI Area
  • Registered: 2014-12-09
  • Posts: 184

Re: Has any one seen this before?

Perhaps a model issue and run it through netfabb?

DaVinci 1.0A with Repetier .92
Simplify 3D
E3DV6

3 Reply by Cardsin2005

  • Cardsin2005
  • Newbie
  • Offline
  • Registered: 2014-12-30
  • Posts: 8

Re: Has any one seen this before?

I am unfamiliar with netfabb. Is it a model repair tool?

4 Reply by twwaters

  • twwaters
  • Member
  • Offline
  • From: Georgia - USA
  • Registered: 2015-10-26
  • Posts: 21

Re: Has any one seen this before?

Are you running stock firmware or reflashed with repetier?  Here is a link of other users with the same problem.  It seems to be a problem with some of the stepper motor wires.   http://voltivo.com/forum/davinci-peersu … port-group

5 Reply by mpoffo (edited by mpoffo 2015-12-20 21:53:32)

  • mpoffo
  • Member
  • Offline
  • From: Milwaukee WI Area
  • Registered: 2014-12-09
  • Posts: 184

Re: Has any one seen this before?

Cardsin2005 wrote:

I am unfamiliar with netfabb. Is it a model repair tool?

I agree it could the wires but here is a link the online netfab model repair service.  Sometimes it helps to correct stubborn models.

https://netfabb.azurewebsites.net/

DaVinci 1.0A with Repetier .92
Simplify 3D
E3DV6