<![CDATA[SoliForum - 3D Printing Community — Has any one seen this before?]]> https://www.soliforum.com/topic/13119/has-any-one-seen-this-before/ Sat, 19 Dec 2015 04:56:09 +0000 PunBB <![CDATA[Re: Has any one seen this before?]]> https://www.soliforum.com/post/112117/#p112117 Cardsin2005 wrote:

I am unfamiliar with netfabb. Is it a model repair tool?

I agree it could the wires but here is a link the online netfab model repair service.  Sometimes it helps to correct stubborn models.

https://netfabb.azurewebsites.net/

]]> Sat, 19 Dec 2015 04:56:09 +0000 https://www.soliforum.com/post/112117/#p112117 <![CDATA[Re: Has any one seen this before?]]> https://www.soliforum.com/post/112028/#p112028 Are you running stock firmware or reflashed with repetier?  Here is a link of other users with the same problem.  It seems to be a problem with some of the stepper motor wires.   http://voltivo.com/forum/davinci-peersu … port-group

]]> Fri, 18 Dec 2015 05:24:22 +0000 https://www.soliforum.com/post/112028/#p112028 <![CDATA[Re: Has any one seen this before?]]> https://www.soliforum.com/post/112026/#p112026 I am unfamiliar with netfabb. Is it a model repair tool?

]]> Fri, 18 Dec 2015 04:58:30 +0000 https://www.soliforum.com/post/112026/#p112026 <![CDATA[Re: Has any one seen this before?]]> https://www.soliforum.com/post/112014/#p112014 Perhaps a model issue and run it through netfabb?

]]> Fri, 18 Dec 2015 03:36:18 +0000 https://www.soliforum.com/post/112014/#p112014 <![CDATA[Has any one seen this before?]]> https://www.soliforum.com/post/112010/#p112010 I am was printing a new carriage for the DaVinci and it failed twice in a strange way.

http://soliforum.com/i/?Ng7XbZL.jpg
http://soliforum.com/i/?9VCu06U.jpg

As you can see the X axis all of a sudden starting printing exactly 25mm off. the Y was fine. Both prints did this at almost the exact some or the exact same layer. I also re-sliced it between prints, and even added other prints to the print bed. So I don't know if is an error with the .STL or if my printer is messing it up. What do you guys think?

]]> Fri, 18 Dec 2015 03:07:08 +0000 https://www.soliforum.com/post/112010/#p112010