1 Topic by clydehargis

  • clydehargis
  • Member
  • Offline
  • Registered: 2015-06-27
  • Posts: 11

Topic: Need source for replace SD4 x motor.

Need a source/link for a replacement SD4 x motor.
Any assistance would be greatly appreciated.

2 Reply by AZERATE

  • AZERATE
  • AZERATE
  • PRINTiT
  • Offline
  • From: Chicago
  • Registered: 2013-11-28
  • Posts: 2,077

Re: Need source for replace SD4 x motor.

http://www.omc-stepperonline.com/nema-1 … -p-93.html looks like a winner.

When shopping for replacement motors, refer to the Soliwiki.com page on compatible hardware and scroll down to motors. It will give a link with specs, but omc-stepperonline.com is my personal go to, and is for several other users as well. The motors are cheap and service is quick, so I would suggest picking up some extra ones to play around with. I gave a winded review here discussing a .9 degree motor mod for the extruder if you wanted to experiment.

Printit Mason and Printit Horizon printers
Multiple SD2s- Bulldog XL, E3D v5/v6/Lite6, Volcano, Hobb Goblin, Titan, .9 motor, Lawsy carriages, direct Y drive, fishing line...the list goes on
Filawinder and Filastruder #1870.....worth every penny!

3 Reply by mdrVB6 (edited by mdrVB6 2015-11-23 13:16:16)

  • mdrVB6
  • Member
  • Offline
  • Registered: 2013-12-18
  • Posts: 717

Re: Need source for replace SD4 x motor.

+1 for that site but the link provided was to the global site, which means it will ship from China.  Click the link at the top to take you to use US site (assuming that is where you are located) and it will ship cheaper.  I got this for for a little more torque (the extra weight has not mattered) and it works great:

http://us.stepperonline.com/nema-14-hig … -p-59.html

SD4 w/ RUMBA, E3D Volcano, all bearings, glass bed

4 Reply by clydehargis

  • clydehargis
  • Member
  • Offline
  • Registered: 2015-06-27
  • Posts: 11

Re: Need source for replace SD4 x motor.

This community is amazing, thank you all!

5 Reply by mdrVB6

  • mdrVB6
  • Member
  • Offline
  • Registered: 2013-12-18
  • Posts: 717

Re: Need source for replace SD4 x motor.

If you order it, ask the extra long cables and setup for the type of board connection that you need.  I'll be impressed if they can do that.  It says they offer it, but I've never tried.

SD4 w/ RUMBA, E3D Volcano, all bearings, glass bed