Da Vinci 1.0A and AIO firmwares - Direct Download of the current vers

is there anyway to modify firmware once it has been compiled like this?

Remember that 1.0A 2.0A and Aio use the new board. The repository for older boards are umm on other postI dont remember. This is for ppl that want to backup this firmwares incase they wan't to try repetier.

I do have the new board.  I was on 1.0.3, flashed over to Repetier, and now trying to flash back to stock.

I readed somewhere that pressing up and down while turning on allowed someoneto make the machine show varely so the updater could work. I'll try to find the post

Is it posible to backup a copy of the firmware on my machine? I read somewhere that you can backup arduino firmwares

There's a file named FW_upgrade.dat on the minisd card that is about the same size as other firmware files.  I wonder if that's usable.

@georgehine  I tried push loading the firmware using the softwares in your link with no luck.  The push load seems to go through fine, but the LCD is stuck on UPDATING, PLEASE WAIT.  The printer then goes back to the 2 black bars if I turn it off and back on.  I contacted XYZ support anyway and see what they say.   Worst case scenario I'll just flash to Repetier again.

where you ever able to get you aio printer back up and running? I made the huge mistake to try and flash mine and now when i turn it on it just have 2 black bars as well I need help bad

I have been working with the davinci aio for several hours now. Here’s what I have come up with. I have successfully installed 1.1.j on it (even though it’s for the 1.0 not aio) and I have got repetier on it as well. Those both seem to work fine. The only other firmware I have tried is 1.1.3. I have the xyzerocart and that was allowing me to dictate what material and how long the filament was for the printer, but I was not able to modify any temperatures. Supposedly, the xyzerocart will give you full control on version 1.1.3 in the aio and that is why I tried to revert back. I do still want the functionality of the scanner, but at the same time, would like the freedom to alter the bed and extruder temps. Unfortunately there seems to be some sort of status somewhere else on the board that will not let previous versions of the firmware on there. I even opened up the bin file with a hex editor and altered the code that read 1.1.3 to 1.1.5 and that still did not work. There must be something else in the bin file that lets the machine know its 1.1.3 and there must be somewhere else on the machine that regulates versions that are allowed to be installed. I failed to pull the .dat file from the SD card before I tried to downgrade and now I can’t even try to put 1.1.5 back on. If anyone has version 1.1.5, or has not hacked their aio, would you be willing to get me that file from your SD card inside the machine? I would also like to compare both files’ hex data as well.  All you have to do is pull the SD card out and copy the files from it. The file I need is FW_upgrade.dat if you have not tried to modify your aio.

I just got my AiO back from XYZ Printing because of a hardware failure and they upgraded my system to 1.1.5, so my ZEROCart system no longer talks to the system. If you can tell me how to get the file off the SD card, I'll be glad to do it. I want to get my ZEROCart system back up and running - I have a lot of non-XZY filament sitting here waiting to print.