Topic: Printer not heating up
I've come to heat my printer up to put filament in and it just says DEF next to the temps and is not warming up. Attached a picture to help people understand
Hope some one can help
Re: Printer not heating up
I have since changed out the thermister twice and this time when i connect it it reads 359 and then reads def
Really don't know what to do and am getting desperate for help here
- carl_m1968
- Member
- Offline
Re: Printer not heating up
Is this a stock machine or modified? I don't remember what the stock LCD looks like.
Printing since 2009 and still love it!
Anycubic 4MAX best $225 ever invested.
Voxelabs Proxima SLA. 6 inch 2k Mono LCD.
Anycubic Predator, massive Delta machine. 450 x 370 print envelope.
Anycubic 4MAX best $225 ever invested.
Voxelabs Proxima SLA. 6 inch 2k Mono LCD.
Anycubic Predator, massive Delta machine. 450 x 370 print envelope.
4 2015-07-05 23:46:34 (edited by luc 2015-07-05 23:46:53)
Re: Printer not heating up
sensor defect, so you are in dry mode to avoid problem
if you said you read 359 when starting, because sensor has a limit of 300, over this temperature it consider the measurement has a problem, so it go to dry mode to prevent heating.
You also can connect repetier to see what temperature is measured, def is only on LCD
Looks like sensor problem, if at room temperature it give 359 degres, it is not normal
Re: Printer not heating up
Yeah it's cold but reads 359 then errors out. It's a new sensor. If it happens with the E3D official one then I'm parting the machine out getting another different one
Re: Printer not heating up
And no this is running repertier 0.91
7 2015-07-06 06:00:48 (edited by luc 2015-07-06 06:03:07)
Re: Printer not heating up
you cannot use any thermistor on Davinci because it has additionnal resistor, so table need to be modified, it cannot be use as it is
Re: Printer not heating up
http://e3d-online.com/Spares/Thermistor-Replacement-Kit
This is the actual sensor from an E3D this work before I just ordered a new one to see if that will work