Topic: Higher resolution slicing settings
Is there a particular set of parameters that are ideal for skeinforge for slicing at .1mm? I want the objects to have more detail, and am having some issues.
You are not logged in. Please login or register.
SoliForum - 3D Printing Community → Software & Firmware → Higher resolution slicing settings
Is there a particular set of parameters that are ideal for skeinforge for slicing at .1mm? I want the objects to have more detail, and am having some issues.
I would switch to Repetier host and Slic3r if you want to do .1mm layers. SD provides profiles for .1mm.
http://www.soliforum.com/topic/121/repe … olidoodle/
SD?
Does it still run on Python?
I am just getting the hang of Pronterface/skeinforge. Am I going to have to learn all over again?
SD?
Does it still run on Python?
I am just getting the hang of Pronterface/skeinforge. Am I going to have to learn all over again?
Pronterface/Skeinforge is a joke. Repetier host will make life much easier for you.
SD=Solidoodle
dindenver wrote:SD?
Does it still run on Python?
I am just getting the hang of Pronterface/skeinforge. Am I going to have to learn all over again?
Pronterface/Skeinforge is a joke. Repetier host will make life much easier for you.
SD=Solidoodle
A lot of Linux folks still like Skeinforge. You'll notice it's still pretty widely used. It compares pretty well to some of the other alternatives. I think there needs to be a solution for folks who want less "747 cockpit" and more "press control P to print"
Just my 2 cents.
SoliForum - 3D Printing Community → Software & Firmware → Higher resolution slicing settings
Powered by PunBB, supported by Informer Technologies, Inc.