Awesome! Thanks for sharing.
In Slic3r there are 4 tabs across the top of the latest release of software and along the right side there are 3 drop down selectors for [Print] [Filament] and [Printer]. You usually only select Printer once, unless you have more than one, then change Filament parameters when you change filament and then you usually change something on each Print if the needs warrant. (they usually do). I think everything you provided was from the Print tab.
Did you create your own DaVinci1.0 printer config and DaVinci1.0 filament config? If so, could you share those too?
-- ggunners
SD2 Expert stock, ABS fume fan,
XYZ DaVinci 1.0 stock ABS, Simplify3D
QUBD Two-Up PLA, new 3D printed X gantry, Y idler, flex z coupler, extruder mount, E3D Lite