Topic: Heated build chamber
Hi everyone,
I'm currently building a temperature controlled heated build chamber and I'm
aiming around 55°c for the ambient temp since that's what a stratasys 3d
printer temp usually runs for ambient temp.
I currently made the metal case, which is 20ga cold rolled steel sheet.
I also applied a black diamond powder coat to make it pop
Here's without the powder coat
Freshly taken out of the oven in my shop with the powder coat
Tested fitted after the powder coat
I'm currently looking at options to keep the ambient temp up
any ideas?
I've seen regulars lamps, IR lamps, and even a heated build platform attached to the side of the case.
Should I go with a IR lamp like this one?
http://www.amazon.com/Zoo-Med-ReptiCare … +HEAT+LAMP